- • Requirements for the controlled devices
- • Dashboards, Zones, Categories
- • Simple thermostat with hysteresis
- • Simple Heating management using Weekly schedule and Presence switch
- • Power limiting
- • Notification on high temperature (DEPRECATED)
- • Configuring hysteresis control via Equation Smart Rule
- • PID Temperature regulation
- • PID Cascade
- • Regulation of Boiler Cascade
- • Equithermic regulation
- • Heating control in high electricity tariff via load management tariff indicator input
- • Heating and Cooling modes
- • Editing multiple devices at once
- • Setting the response speed of push buttons
- • Integrate multiple control units Core
- • Safe values
- • How to combine two daily schedules in one day
- • Linking devices together
- • Device log
- • Using statistic values in Smart Rules
- • Hot water circulation pump control
- • Exporting data from TapHome into Google Spreadsheet using Integromat
- • Exporting device descriptions
- • 2024.1
- • 2023
- • 2022.2
- • 2022.1
- • 2021.3
- • 2021.2
- • 2021.1
- • 2020.1
- • 2019.1
- • 2018.1
- • 2017.1 - Blinds automation - angle control update
- • 2017.1 - Blinds automation - Depth of sun rays
- • 2017.1 - Charts updated
- • 2017.1 - Core update from the app
- • 2017.1 - Double click and triple click
- • 2017.1 - Expose devices
- • 2017.1 - Multi-value switch
- • 2017.1 - Permissions
- • 2017.1 - Replace module action
- • 2017.1 - Set to Automatic mode - "Push buttons event" Smart Rule
- • 2017.1 – Daily schedule Smart Rule
- • Firmware changelog
- Documentation
- Configuration
- Shading
- DC blinds, slides, awnings with Encoder signal
DC blinds, slides, awnings with Encoder signal
Position of DC blinds.
Service settings of blinds
Normal operation current
All calibration parameters are the same as for AC blinds, except for one extra parameter:
Normal operation current | Default value |
---|---|
Set reverse motor direction | Off |
Encoder settings
Calculation of position and angle of blinds is based on counting impulses from encoder
Encoder settings section consists of following attributes:
Attribute | Default value |
---|---|
Max time to wait for encoder signals start in up direction | 150 ms |
Max time to wait for encoder signals start in down direction | 150 ms |
Number of impulses total | 2000 |
Number of impulses for angle change Not applicable for slides. | 103 |
Number of impulses for angle change Not applicable for slides. | 103 |
Calibration current | 71% |
Normal operation current Limit of current during calibration. | 71% |
Normal operation current | 83% |
Normal operation current Limit of current during normal operation up. | 83% |
Normal operation current down | 38% |
Normal operation current down Limit of current during normal operation down. | 38% |
Maximal current down change | 250% |
Maximal current down change Prevent reloading blind up in case when it is moving down. Stops blind moving down in case the current down is higher than average current down in defined percent. | 250% |
Impulses per second to regulate speed. | 0 |
Impulses per second to regulate speed. Holds constant speed by using the number of impulses per second. If this is not possible to reach it holds higher possible or lower possible speed. To disable speed control set to 0. | 0 |
Minimal PWM value. | 50 |
Minimal PWM value. Set minimal PWM value to regulate blind speed or to use soft start and soft end. | 50 |