The basic setup consists of real blind, two relay outputs (up and down) to control the motor and two push button inputs to control level and angle of blinds.

Go to the output module where the motors are physically connected, enable Blind under Blinds section. Choose the outputs for phase up and phase down for the motor control.

To assign Control buttons to the blind, go to the input module where the push buttons are physically connected, find the right two inputs and enable them as Push buttons.

In order to set durations for the blinds motors, please use Blinds configuration wizard

Now you have Blinds with manual control via physical push buttons.

In order to set durations for the blinds motors, please use Blinds configuration wizard