- • Requirements for the controlled devices
- • Dashboards, Zones, Categories
- • Simple thermostat with hysteresis
- • Simple Heating management using Weekly schedule and Presence switch
- • Power limiting
- • Notification on high temperature (DEPRECATED)
- • Configuring hysteresis control via Equation Smart Rule
- • PID Temperature regulation
- • PID Cascade
- • Regulation of Boiler Cascade
- • Equithermic regulation
- • Heating control in high electricity tariff via load management tariff indicator input
- • Heating and Cooling modes
- • Editing multiple devices at once
- • Setting the response speed of push buttons
- • Integrate multiple control units Core
- • Safe values
- • How to combine two daily schedules in one day
- • Linking devices together
- • Device log
- • Using statistic values in Smart Rules
- • Hot water circulation pump control
- • Exporting data from TapHome into Google Spreadsheet using Integromat
- • Exporting device descriptions
- • 2024
- • 2023
- • 2022.2
- • 2022.1
- • 2021.3
- • 2021.2
- • 2021.1
- • 2020.1
- • 2019.1
- • 2018.1
- • 2017.1 - Blinds automation - angle control update
- • 2017.1 - Blinds automation - Depth of sun rays
- • 2017.1 - Charts updated
- • 2017.1 - Core update from the app
- • 2017.1 - Double click and triple click
- • 2017.1 - Expose devices
- • 2017.1 - Multi-value switch
- • 2017.1 - Permissions
- • 2017.1 - Replace module action
- • 2017.1 - Set to Automatic mode - "Push buttons event" Smart Rule
- • 2017.1 – Daily schedule Smart Rule
- • Firmware changelog
- Documentation
- Initial setup
- LED indications of Bus modules
LED indications of Bus modules
Information below is available for TapHome Bus modules with firmware version 25 or above.
Informative states
LED | Description |
|---|---|
 ON | Device is powered and communicates with Core control unit. |
 EVEN FLASHING | Configuration dialog in iOS or Android app for this module is currently open. (/) This way you can identify module that you are configuring, and rename it for future reference |
LED | Description |
|---|---|
1 FLASH | Device is powered, but receives invalid communication packets. (x) Check if bus is wired correctly (x) Check if A and B terminals are connected in correct order (x) Check if 100Ohm termination resistor is placed at the end of bus wire between A and B (x) Check if device is connected on TapHome Bus wires. Connecting TapHome device on Modbus or other protocol would cause invalid packets on TapHome module, that would be displayed as 1 flash |
 2 FLASHES | Device is powered and has valid communication with Core control unit, however messages are not directed towards this module. (/) Everything is ready, but module has not been scanned (Hardware → TapHome Bus → Find new devices) |
3 FLASHES | Device is powered, but does not hear any communication. (X) Check if proper BUS terminal is enabled in Hardware → TapHome Bus → Terminals |
 OFF | Device is not powered or not working correctly. (X) Check if there is 24VDC between +24 and GND terminal. Tolerance is ±10%. |
