Search
MENU
- • Editing multiple devices
- • Basic Blinds Setup
- • Blinds configuration wizard
- • Light switching
- • Lighting timer basics
- • Heating and Cooling modes
- • Power limiting
- • Notification on high temperature
- • Configuring hysteresis control via Equation smart rule
- • Equithermic regulation
- • PID Temperature regulation
- • PID Cascade
- • Regulation of Boiler Cascade
- • Using statistic values in smart rules
- • Integrate multiple Core control units
- • Safe Values
- • How to combine two daily schedules in one day
- • Simple thermostat with hysteresis
- • Simple Heating management using Weekly schedule and Presence switch
- • Dimmer limits
- • Grouping or linking devices together
- • Access control
- • Static IP address configuration
- • 2019.1 - release planned for Q3 2019
- • 2018.1
- • 2017.1 - Charts updated
- • 2017.1 - Blinds automation - Depth of sun rays
- • 2017.1 - Blinds automation - angle control update
- • 2017.1 - Replace module action
- • 2017.1 - Expose devices
- • 2017.1 – Daily schedule smart rule
- • 2017.1 - Permissions
- • 2017.1 - Double click and triple click
- • 2017.1 - Set to Automatic mode - "Push buttons event" smart rule
- • 2017.1 - Multi-value switch
- • 2017.1 - Core update from the app
- • Firmware changelog
2017.1 - Blinds automation - angle control update
The smart rule Control blinds with Up and Down push buttons has been updated to choose behavior type and to enable to keep blinds down and only allow control of the angle.
- Behavior type Short press: When the button is pressed, the blinds travel all the way up or down. Another press stops them. If the option Allow only change of slats angle is checked, the angle changes from 0% to 100% or vice versa depending on the previous movement direction.
- Behavior type Short and long press: On short press, blinds only change angle by 25%. E.g. if these are 90 degrees blinds, they change their angle by 0.25 * 90 = 22.5 degrees. Long press sends them all the way up or down. In case the checkbox Allow only change of slats angle is checked, long press changes the angle either to 0 degrees or to 90 / 180 degrees depending on the type of blinds.
