Search
MENU
- • Editing multiple devices
- • Basic Blinds Setup
- • Blinds configuration wizard
- • Light switching
- • Lighting timer basics
- • Heating and Cooling modes
- • Power limiting
- • Notification on high temperature
- • Configuring hysteresis control via Equation smart rule
- • Equithermic regulation
- • PID Temperature regulation
- • PID Cascade
- • Regulation of Boiler Cascade
- • Using statistic values in smart rules
- • Integrate multiple Core control units
- • Safe Values
- • How to combine two daily schedules in one day
- • Simple thermostat with hysteresis
- • Simple Heating management using Weekly schedule and Presence switch
- • Dimmer limits
- • Grouping or linking devices together
- • Access control
- • Static IP address configuration
- • 2019.1 - release planned for Q3 2019
- • 2018.1
- • 2017.1 - Charts updated
- • 2017.1 - Blinds automation - Depth of sun rays
- • 2017.1 - Blinds automation - angle control update
- • 2017.1 - Replace module action
- • 2017.1 - Expose devices
- • 2017.1 – Daily schedule smart rule
- • 2017.1 - Permissions
- • 2017.1 - Double click and triple click
- • 2017.1 - Set to Automatic mode - "Push buttons event" smart rule
- • 2017.1 - Multi-value switch
- • 2017.1 - Core update from the app
- • Firmware changelog
DMX
The example below shows how to integrate DMX into Taphome via Taphome DMX Gateway.
1. STEP: Connect DMX GATEWAY to any Taphome BUS terminal. It can be at the terminal along with other Taphome modules.
2. STEP: Set up DMX Gateqay within Taphome application
a) Make sure that terminal is linked to TapHomeBus CCU within the Hardware settings page
b) Start "Find new devices" scan within TapHome Bus settings page
c) After successful scan open DMXG device within TapHome Bus settings page
d) Use "+ Add device" to add new DMX device
e) The result
