- • Requirements for the controlled devices
- • Dashboards, Zones, Categories
- • Simple thermostat with hysteresis
- • Simple Heating management using Weekly schedule and Presence switch
- • Power limiting
- • Notification on high temperature (DEPRECATED)
- • Configuring hysteresis control via Equation Smart Rule
- • PID Temperature regulation
- • PID Cascade
- • Regulation of Boiler Cascade
- • Equithermic regulation
- • Heating control in high electricity tariff via load management tariff indicator input
- • Heating and Cooling modes
- • Editing multiple devices at once
- • Setting the response speed of push buttons
- • Integrate multiple control units Core
- • Safe values
- • How to combine two daily schedules in one day
- • Linking devices together
- • Device log
- • Using statistic values in Smart Rules
- • Hot water circulation pump control
- • Exporting data from TapHome into Google Spreadsheet using Integromat
- • Exporting device descriptions
- • 2025
- • 2024
- • 2023
- • 2022.2
- • 2022.1
- • 2021.3
- • 2021.2
- • 2021.1
- • 2020.1
- • 2019.1
- • 2018.1
- • 2017.1 - Blinds automation - angle control update
- • 2017.1 - Blinds automation - Depth of sun rays
- • 2017.1 - Charts updated
- • 2017.1 - Core update from the app
- • 2017.1 - Double click and triple click
- • 2017.1 - Expose devices
- • 2017.1 - Multi-value switch
- • 2017.1 - Permissions
- • 2017.1 - Replace module action
- • 2017.1 - Set to Automatic mode - "Push buttons event" Smart Rule
- • 2017.1 – Daily schedule Smart Rule
- Documentation
- Initial setup
- LED indications of Core unit
LED indications of Core unit
LED 1: Core up to version 1.4 - Power Core Version 2.0 and higher: Triple flashing after turning the power on indicates the start of the system (booting). In other cases, it indicates the communication status with other modules on the TapHome bus (for more information, see the section "LED module LED indications")
LED 2: System running. Established connection to local network.
LED 3: connected to cloud. Remote access is available.
Error states
| LED 2 LAN | LED 3 Internet | Description |
|---|---|---|
 OFF | OFF | System does not boot up |
FLASH QUICKLY | OFF | LAN cable is disconnected |
 FLASH | OFF | Device does not have IP address assigned |
 ON | FLASH | TapHome Core firmware is not running |
ON | FLASH | TapHome Core firmware cannot connect to the Cloud |
ON | OFF | TapHome Core firmware cannot connect to the Cloud |
FLASH |
FLASH | Device has problem with DNS settings |
 FLASH QUICKLY | FLASH QUICKLY | Device cannot connect to the internet |
ON | ON | TapHome Core firmware is running and is connected to the Cloud |