Requests for new device templates and the tools to build them.
Following a topic emails you when a new idea is published in it and when one is released. Status changes go only to people who follow the idea itself.
Read and set a Vaillant heat pump with the sensoCOMFORT VRC 720 from TapHome: temperatures, room and hot water setpoints, modes, hot water boost, energy and errors, through the eBUS Adapter C6 with micro-ebusd. A beta template is in the TapHome portal.
Control Somfy io roller shutters, awnings and exterior venetian blinds and send commands to RTS motors from TapHome through the local Developer Mode API of a TaHoma gateway. A beta template is in the TapHome portal.
Read the waterproof Sonoff SNZB-02LD Zigbee temperature probe in TapHome through a gateway with Tasmota firmware, for example as a wireless floor sensor for underfloor heating, with the battery level and an offline warning. A beta template is in the TapHome portal.
Connect IVT heat pumps with the Rego 2000 controller to TapHome through the Husdata H66 gateway: heat pump state, operating mode including cooling, blocking of heating or cooling and errors as warnings.
Set the LinkedGo ST802-B fan coil thermostat (Powered by Shelly) from TapHome over its local Wi-Fi API: target temperature, fan speed, working mode, on/off, anti-freeze and target humidity, with room temperature and humidity. A beta template is in the TapHome portal.
A short record of the messages a Packet Parser module sends and receives, with time, direction, MQTT topic or address and content, shown in its service settings while you troubleshoot. No network sniffer needed, and only the module's own messages, not the whole network.
Roller shutters and awnings connected through Packet Parser templates would get the same Sun orientation settings as shutters on TapHome modules, so the smart rule Blinds adjustment according to sun can move them by the sun.
Sign in with your TapHome account to follow. We email you when something changes; unsubscribe in one click.
Confirming your vote…
How helpful was this?
We'll pass your question to our technicians. We usually reply within 24 hours.
We only offer installations where you have Admin or Service. Core 1 does not get the beta — the assistant will tell you.
✦
🌙 The support assistant is away right now. The reply comes when it is back.
For a reply by e-mail, use "Leave a contact" in the AI Assistant.
We need you to sign in so the assistant can see which installations you have Admin or Service on.
We can't see an installation with the Admin or Service permission on your account — the assistant replies without looking into an installation. For a reply by e-mail, use "Leave a contact" in the AI Assistant.
Support will see the page, your question and your conversation with the AI Assistant.
The reply comes to WhatsApp on your phone.
The WhatsApp message was not sent within 60 minutes.
You are among the first partners who can roll out 2026.1 to customers. The support assistant does the upgrade for you on WhatsApp or by e-mail — it checks the unit and makes a backup before the change.
Try 2026.1 before everyone else. The support assistant does the upgrade for you on WhatsApp or by e-mail — it checks the unit and makes a backup before the change.
The beta may contain bugs. We make a backup before the upgrade.
Your question is with our technicians. Meanwhile, feel free to keep asking.
